Condition · Support-Loss Family


Soil Erosion and Washout Mean the Support Soils Are Moving or Disappearing

Understand how water-driven soil migration reduces support, why washout creates larger performance problems over time, and which repair direction fits the actual support-loss condition.

Condition-first guidance

Support-loss clarity

Project-specific support

The short answer

What are soil erosion and washout?

Soil erosion and washout occur when water moving through the ground carries away the fine soils that support a structure, slab, pavement, or embankment, reducing or removing support from below and producing the settlement, cracking, edge loss, or instability seen at the surface.

Why this matters

Erosion becomes a structural problem when support starts to disappear

Soil erosion and washout matter because they reduce or remove the soils that structures, slabs, pavements, seawalls, and embankments depend on. The visible symptom may be settlement, cracking, edge loss, seepage, undermining, or hollow zones. The real problem is that the support soils are moving, weakening, or disappearing.

Cutaway of water flowing through a slab joint and washing out the soil beneath

Diagnosis Before Method™

The difference between a repair that lasts and one that fails. 


Identify what's actually failing below the surface before selecting a repair method.
These four steps are how that decision gets made.

Diagnosis

01

Identify the visible symptom

The crack, settlement, water entry, or movement you can actually see.

02

Understand what changed below

The water, soil, void, or loss of bearing driving it beneath the surface.

Then select the method

03

Match the method to what failed below

Choose the repair that addresses the cause, not just the visible symptom.

04

Confirm the correction holds

Verify the repair is backed by conditions stable enough to last.

Mechanism

Why washout develops

Washout develops when flowing water, seepage, pressure conditions, leaking utilities, poor drainage, changing hydraulic paths, or repeated wetting move fines or loosen soils over time. As the soil structure changes, support is reduced and the performance of the structure above becomes less reliable.

Failed buried pipes are one of the most common, and most overlooked, causes. A broken pressurized water line beneath a slab can wash out the supporting soil quickly, undermining the slab in a short time. Leaking drainage and sewer lines usually erode more slowly, carrying fines away over time until the loss shows up as a void, a soft spot, or settlement at the surface. Because the pace and the signature differ, confirming whether a pipe is involved, and which kind, is often central to finding the real source of the loss.

Sequence showing water seeping through slab cracks and eroding cavities in the soil over time

If this condition is misread

Treating the symptom without finding the source of the loss tends to make the problem bigger

Expanding washout, recurring settlement, broader instability, and a growing repair footprint can follow when erosion-driven conditions are treated without clarifying the actual loss path.

Where the loss is occurring

The right repair method depends on where the support loss is occurring

Some erosion conditions are tied to shallow support loss beneath slabs or pavements. Others affect retained-soil zones behind seawalls or bulkheads. Others are tied to broader unstable support zones beneath foundations, approaches, or below-grade structures. The repair method must match the location, environment, and driver of the support loss.

Choose your repair method


If the ground itself is weak or washing away

If the erosion is at a seawall, bulkhead, or waterfront edge

Or rule out a different driver first


If a slab or pavement above has dropped

If areas sound hollow underfoot

If soil is disappearing behind a seawall or bulkhead

If movement is broader than one washed-out spot

Paired-method logic

Water movement and soil movement usually belong in the same conversation

Where water is still moving through the soils, support loss can continue even after the surface looks corrected. That is why erosion and washout repairs often require both support restoration and better control of the condition that is moving the soils in the first place.

What a good next step does

A better next step helps you stop the loss, not just patch the symptom

A better next step does more than correct the surface. It helps confirm whether soil is still being carried away, reduces the chance of repeat settlement and rework, and keeps the repair from looking complete while the ground beneath continues to erode.

Project fit snapshot

Match the condition to the likely next step

Project Fit Snapshot

What you’re seeing

Typical next step

Decision trigger

Support loss beneath slabs or pavements tied to washout

Settled Concrete Slabs or Voids Beneath Concrete

The visible symptom is above a changing support zone

General soil support loss from erosion or migration

Soil Stabilization & Settlement Control

The support soils need to be strengthened or stabilized

Waterfront or retained-soil loss condition

Seawall Soil Erosion or Seawall & Waterfront Stabilization

The erosion condition is tied to a marine-facing structure or edge

Active, recurring, or higher-consequence erosion

Technical Services

The condition is still progressing or carries higher risk if misread

Frequently asked questions

It is the loss or weakening of support soils caused by water movement, migration of fines, seepage, leaking utilities, drainage problems, or repeated hydraulic change.

Surface erosion affects exposed soils near the surface. Washout affects support soils below slabs, structures, embankments, or retained zones where hidden support is being removed or weakened.

Yes. As soils are removed or weakened, the structure above can lose support, settle, or develop hidden cavities where contact has been lost.

No. Some of the most important support loss happens below grade and does not become obvious until movement or damage appears later.

Water is often the main driver because it moves fines, opens new paths through the soil, and changes the ground beneath over time.

Repair may involve stabilization, support restoration, void treatment, retained-soil support work, seawall and waterfront stabilization, leak control, or a combined approach depending on what is driving the condition.

Seawall and waterfront stabilization is more likely when the support-loss condition is tied directly to seawalls, bulkheads, waterfront edges, or retained-soil loss in a marine environment.

General stabilization is more likely when the support problem is broader and not limited to a waterfront retaining condition.

Yes. A broken pressurized water line beneath a slab can wash out supporting soil quickly, while leaking drainage or sewer lines tend to erode it slowly over time. Because a failed pipe keeps feeding water to the same place, the loss usually continues until the pipe is found and the water route is addressed, not just the surface symptom.

Request project assistance when the erosion is active, recurring, tied to water, affecting a higher-consequence structure, or difficult to narrow from the page alone.

Proof & Verification

Named Project

Parking Lot Stabilization

A failed culvert 28 feet under a Norcross plant’s lot washed out soil through joints. AP Fill 700 and CIPP repairs fixed the cause for good.
Case Study

Performance Data Point

Loose soil compacted 28 feet down.

Find the source of the loss
before you commit to a repair


Erosion and washout reduce the support soils your structure depends on. Clarify what is actually moving below, then move to the method built for that condition, before scope and cost grow.