Back to Blog

Sealing Leaks - Crack Injection & Curtain Wall Grouting

Crack Injection Explained

Crack injection has many advantages over other methods. For example, if you’re sealing a leak in a water tank, you can inject from the outside of the tank. So the tank can remain in service while you repair it. Having to dry a crack, like you do with epoxy resin, is not needed as this material reacts with water. The material also remains flexible at all times.

Crack injections can be applied in both vertical cracks and in horizontal cracks. With vertical cracks, it is imperative to start at the bottom of the crack and work your way up the crack until it is filled. This forces the material up and through the crack and will simultaneously push the water up and out as well. With horizontal cracks, injection can be started at either the left or right end.

The process begins by drilling injection holes at an angle along the crack, alternating from one side to the other so each hole intersects the crack inside the concrete. Injection packers are installed in the drilled holes, and the crack is typically flushed with water to clear out debris and give the resin water to react with. Resin is then pumped into the first packer until it appears at the face of the crack or at the next packer, and the crew moves to the next packer and repeats the process. Once the resin has cured, the packers are removed and the holes are patched, leaving a flexible, watertight seal through the full depth of the crack.

Curtain Wall Grouting Explained

Curtain wall injection is the process of drilling holes through a structure in a diamond pattern, then injecting the grout into soil on the other side. This procedure creates a curtain wall made of a resin/soil mixture that prevents water from getting back into the structure. It is often required if there are multiple cracks or leaks in a wall. Filling each individual crack may cause you to waste time following the water from crack to crack. Curtain wall grouting allows you to stop multiple leaks at one time and protects the structure on a long term basis.

This procedure was first performed in 1960 on a sewer manhole with a multiple leak problem. As described above, chemical grout was injected through to the outside of the manhole. This created a “positive side seal” (on the side the water was coming from), blocking water from penetrating the joints of the structure.

Today, the process follows the same basic steps. Holes are drilled completely through the wall in a diamond pattern across the leaking area, and an injection packer is set in each hole. Grout is pumped through the packers into the soil behind the wall, typically starting at the lowest row and working upward. As the grout moves into the soil, it reacts with the groundwater and binds with the surrounding soil, and the grout from each injection point overlaps with its neighbors to form a continuous barrier. Injection at each point continues until grout reaches the adjacent holes or the soil will not accept more material. After the grout cures, the packers are removed and the holes are patched.

Illustrations comparing crack injection on a wall crack and curtain wall grouting behind a garage wall

Want more info on crack injection and curtain wall grouting products?